Filter
Top Products
11
Reference
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
To control a cable TV converter:
Program the remote control to recognize the brand of your
converter. The shaded buttons shown on the right will control the
cable TV converter.
Press the CABLE button whenever you control the cable TV
converter.
Programming the remote control for use with a
VCR or a cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs. To
use VCRs or cable converters other than Toshiba models, you must
follow the steps below before you operate your remote control.
1. Refer to the “VCR code table” or “Cable TV converter code
table” on pages 12-13 to find the number that corresponds to the
brand name of your VCR or converter.
If more than one number is listed, try each one separately until
you find the one that works.
2. Turn on the device (VCR or converter) you wish to program the
code.
3. Press the matching device button “VCR” (or “CABLE”) and
ENT at the same time. The device button will be illuminated by
the back-light to indicate that it is in the program mode. Perform
the following steps while the back-light is on (about 20 seconds).
4. Point the remote control toward the VCR (or converter) and
press the Number buttons to enter the three digit code number
for your brand of VCR (or converter).
• If the right number was entered, the VCR (or the converter)
should turn off.
• If the VCR (or the converter) does not respond to the remote
control, repeat steps 1 to 4 with another code number until
the device turns off.
The back-light will blink to confirm the storage.
5. Press the device button (CABLE or VCR) to release the program.
6. Press TV to control the TV.
For future reference, write down the code numbers you used:
VCR code _____________________
Cable code _____________________
Note:
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch, it may
not respond to any of the code numbers for
your VCR brand name. In this case, set the
switch to the other position (VCR1 or
VCR2) and reprogram the remote control.
CH RTN
ADV
ADV
MUTE RECALL
TV/VIDEO SURROUND
+
FAV
C
.
C
A
P
T
R
E
S
E
T
X
D
S
E
X
I
T
-
FAV
VOL
CH
ENTER
1
4
7
2
5
8
3
6
9
0
100
TV
VCR
MENU/
TIMER
POWER
ENT
CABLE
MTS
POWER
Channel
Number
Channel ▲▼
Device buttons
ENT