Filter
Top Products
4
Set up
Preparation
Basic Operation
Advanced Operaion
Reference Section
Introduction
This manual applies to models 27A40, 32A40 and 36A40, and there are slight differences among them.
Check the model of your TV before using this manual.
The 32A40 is the model used for illustration purposes. Illustrations in this manual are based on using the Remote
Control.
Exploring your new TV
You can operate your TV using the buttons on the front panel or the Remote Control.
The back panel provides all the terminal connections you will need to connect other equipment to your TV.
IN
OUT
ANT
S-VIDEO
VIDEO VIDEO
L/
MONO
R
AUDIO
L/
MONO
R
AUDIO
VIDEO
L
Y
R
AUDIO
VIDEO-1 VIDEO-2
C
B
C
R
COLOR
STREAM
INPUT
VOLUME CHANNEL
TS ts
TV/VIDEO
MENU
POWER
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
FF
SLOW
PAUSE
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
Installing Your TV
Where to install
Place the TV on the floor or on a sturdy platform. The
mounting surface should be flat and steady.
Lighting
Do not place the TV in a room where direct lighting
strikes the screen. Use soft and indirect lighting.
Air circulation
Place the TV far enough from the walls to allow
proper ventilation. This will prevent the TV from
overheating and avoid possible damage to the TV.
Avoid dusty places too.
Power supply
Plug into an electrical outlet with standard household
power (120 volt AC, 60Hz). Do not change the plug’s
safety prong. See the right column.
WARNING : TO AVOID PERSONAL INJURY
●
Do not stand or climb on the TV.
●
Do not put a VCR or any heavy object on top of the
TV.
CAUTION :
As a safety feature, the plug has one prong wider than
the other. It will fit only one way into a standard
electrical outlet. If the plug will not fit into the outlet,
try turning it around. If the plug will not fit either way,
the outlet is probably old and non-standard.
You will need to have a new outlet installed by an
electrician.
DO NOT CHANGE
THE SAFETY
FEATURE OF THE
PLUG.
Wide prong