Filter
Top Products
11
(E)27HL85 size213*276
E
S
F
Connecting
your TV
Using the
remote control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
Introduction
Connecting a DVD player or satellite receiver
and a VCR
This connection allows you to watch DVD/satellite, VCR, and TV
programs, and record one TV channel while watching another
channel.
You will need:
• two (or three, if satellite receiver is used) coaxial cables
• one set of standard A/V cables (between the TV and VCR)
• one S-video cable (between the TV and DVD player/satellite
receiver)
• one pair of standard audio cables (between the TV and DVD
player/satellite receiver)
Note:
For the highest possible picture quality from a
DVD player or satellite receiver without
component video, HDMI, or DVI, use an S-
video cable. (If your DVD player has
component video, see page 12. If your DVD
player or satellite receiver has HDMI or DVI,
see page 15.)
Do not connect the DVD player/satellite
receiver and VCR to the same set of Video
inputs on the TV. (See the illustration, which
shows the DVD player/satellite receiver
connected to VIDEO 1 on the TV upper back
panel, and the VCR connected to VIDEO 2
on the TV side panel.)
The unauthorized recording, use,
distribution, or revision of television
programs, videotapes, DVDs, and other
materials is prohibited under the
Copyright Laws of the United States and
other countries, and may subject you to
civil and criminal liability.
IN from ANT OUT to TV
VIDEO AUDIO
LR
IN
OUT
CH 3
CH 4
IN from ANT
VIDEO
OUTOUT
S-VIDEO
VIDEO
OUTOUT
S-VIDEO
AUDIO
OUT
L
R
AUDIO
OUT
L
R
TV upper
back panel
From
Antenna
From
Satellite
Dish
DVD Player
Satellite Receiver
Stereo VCR
TV lower
back panel
TV side panel
(VIDEO-2 IN)
#01E09-15_27HL85 05.5.12, 3:14 PM11
Black