Filter
Top Products
25
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
E
S
F
(E) 32HL83
Learning about the remote control
The buttons used for operating the TV only are described here. For a
complete list of the remote control’s functions, see the “Remote
Control functional key chart” on pages 19–20.
POWER turns the TV on and off
SLEEP allows access to the automatic TV shut-off function (page 53)
LIGHT The first press of the LIGHT button lights the keypad and turns
on the Illumination mode. With the Illumination mode on,
pressing any other key lights the keypad for 5 seconds (10 seconds
if you’re in programming mode).
Subsequent presses of the LIGHT button toggle between turning
the Illumination mode on and off.
Channel Numbers (0-9, 100) allow direct access to channels (page 30)
MODE cycles through the six device modes: TV, CABLE/SAT, VCR,
DVD, AUDIO1, and AUDIO2. The mode indicator light will
remain lit for a few seconds (page 21).
PIC SIZE cycles through the five pictures sizes: Natural, Theater Wide 1,
2, 3, and Full (page 34)
FAVORITE allows access to the favorite channel search function (page 41)
MENU allows access to on-screen programming menus (page 26)
ENTER sets programming menu information (page 26)
yz x • select or adjust programming menus (page 26)
FAV yzcycles through favorite channels (page 32)
CH yz cycles through programmed channels (page 29)
VOL yz adjusts the volume level
EXIT exits the programming menus (page 26)
INPUT selects the video input source (page 50)
MUTE mutes the sound (page 54)
RECALL displays on-screen information (page 60)
CH RTN returns to the last viewed channels (page 31)
POP CH yz selects the POP (picture-out-picture) channel (page 38)
SPLIT turns the POP feature on and off (page 38)
CH SCAN
allows access to the programmed channel search function (page 40)
FREEZE freezes the POP picture (page 39)
SWAP switches the main and POP pictures (page 39)
POP DIRECT CH allows direct access to POP channels (page 38)
SOURCE selects the POP picture source (page 38)
Note:
The error message “Not Available” will appear
if you press a key for a function that is not
available.