Filter
Top Products
16
HMX96 (E/F) Web 213:276
Chapter 2: Using the remote control
Using the remote control to operate
your other devices
Your TV remote control has one dedicated TV mode and five
programmable multi-brand modes: CABLE/SAT, DVD,
VCR/PVR, AUX 1, and AUX 2. The default device modes
and programmable device modes are listed below.
Note: The TV remote control is preprogrammed to operate
most Toshiba devices. To operate a non-Toshiba device or a
Toshiba device that the remote control is not preprogrammed
to operate, you will need to program the remote control. See
“Programming the remote control to operate your other
devices” (at right).
Note: Although your new TV’s remote control includes codes
for many devices, it may not include codes for some or all of
the features on certain devices you wish to control. If you are
unable to program the TV’s remote control to operate your
device or some of the features on that device, use the device’s
remote control or the controls on the device.
Programming the remote control to
operate your other devices
Device code setup
1
Find the code for your device brand in the remote control
device code table on pages 18–21.
If more than one code is listed, try each one separately
until you find one that works.
2 Press the applicable mode select button (CABLE/SAT,
DVD, VCR/PVR, AUX 1, or AUX 2), until the device
button LED blinks 3 times.
3 While holding down E, press the Number buttons to
enter the device category code “0–5” shown below plus
four-digit code for your device.
• If a valid code is entered, the device button LED will
blink twice.
• If an invalid code is entered, the device button LED will
blink one long blink.
4 Point the remote control at the device and press p to test
the code.
• If the device responds to the remote control, you have
entered the correct code.
• If the device does not respond to the remote control,
repeat steps 3 and 4 using another code.
Note: After programming the remote control, make sure
all necessary keys on the TV remote control (in addition to
p) operate your device. If some keys are not
operational, repeat the device code setup using another
code (if other codes are listed for your device). If, after
trying all listed codes, the necessary keys do not operate
your device, use the device’s original remote control.
MODE SELECT
Default device mode control (before
programming)
TV Toshiba TV
CABLE/SAT Toshiba DST 3100 Satellite receiver
DVD Orion DVD
VCR/PVR Toshiba VCR
AUX 1 Yamaha Audio receiver
AUX 2 Onkyo Audio receiver
MODE SELECT Device mode control after programming
TV Toshiba TV
CABLE/SAT
Multi-brand video/audio devices
DVD
VCR/PVR
AUX 1
AUX 2
Category Device code
TV (Toshiba) 0
Cable box
Satellite receiver
Cable/PVR combo
DBS/PVR combo (1)
1
DVDs 2
VCRs
PVRs
DBS/PVR combo (2)
3
Audio Amp
Audio Amp/Tuners
4
CD Players 5
HMX96_EN.book Page 16 Friday, April 28, 2006 12:03 PM