Toshiba 50HMX96 Projection Television User Manual


 
9
HMX96 (E/F) Web 213:276
Chapter 1: Introduction
TV back panel connections
For an explanation of cable types and connections, see the Installation Guide.
1234 6
7
5
1 VIDEO 1 IN — Composite video and analog audio inputs
plus optional S-video inputs for connecting devices with
composite video or S-video output.
Note: Composite video and S-video cables carry only
video information; separate audio cables are required for
a complete connection.
2 ColorStream
®
HD-1 IN and ColorStream
®
HD-2 IN
— Two sets of ColorStream
®
high-definition component
video inputs (with analog stereo audio inputs) for
connecting devices with component video output, such as
a Toshiba DVD player with ColorStream
®
.
Note:
Component video cables carry only video information;
separate audio cables are required for a complete
connection.
HDMI 1 (and 2) share analog audio inputs with
ColorStream HD-1 (and HD-2). To specify the use of the
audio inputs for a connected ColorStream (component
video) device, see “Setting the ColorStream HD audio
mode” on page 28.
3 Variable Audio OUT — Standard analog audio outputs
for connecting an analog amplifier with external speakers.
4 A/V OUT — Standard composite video and analog audio
outputs for connecting a VCR for editing and dubbing.
Note: The A/V OUT terminals will output AUDIO ONLY (no
video) in the following instances:
When the TV's INPUT mode is HDMI, ColorStream, or
PC (- “Selecting the video input source to view,”
page 32).
When the POP window is open (- page 40).
When the MP3 Audio Player is active (- page 67).
5 PC IN — For use when connecting audio and video from
a personal computer to use the TV screen as the display
for the PC (- Installation Guide).
6 IR OUT — For controlling infrared remote-controlled
devices through the TV. You can connect up to two
devices with an IR blaster cable, and then control the
devices using the TV’s IR pass-through features.
7 ANT 1 and ANT 2 — Two inputs that support analog
(NTSC) and digital (ATSC) off-air antenna signals and
analog and digital Cable TV (QAM) signals.
Note: If you have an antenna only, connect it to ANT 1. If
you have both cable TV and an antenna, connect the
cable TV to ANT 1 and the antenna to ANT 2.
(continued)
HMX96_EN.book Page 9 Friday, April 28, 2006 12:03 PM