Filter
Top Products
16
Connections
PC Input connection
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines may not be displayed properly.)
(2) The signal resolution is a maximum of 1024 × 768 dots when the aspect mode is set to “NORMAL”, and 1366 × 768
dots when the aspect mode is set to “FULL”. If the signal resolution exceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you
will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with an MS-DOS 5 (or greater) compatible D-sub 15P port.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies on the PC for PC signals which are above or below the
specified frequency range.
Signal Names for D-sub 15P Connector
Pin No.
1
2
3
4
5
Pin No.
6
7
8
9
10
Pin No.
11
12
13
14
15
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Signal Name
GND (Ground)
SDA
HD/SYNC
VD/SYNC
SCL
AUDIO
PC IN
COMPUTER
Gender changer (if necessary)
Audio
RGB
D-sub 15p
1/8" (3mm) stereo plug
PC cable
Connect a cable which matches
the audio output port on the computer.
POWER /
R - STANDBY
G POWER ON
INPUT
—
VOL
+
Less than
7
7
/
8
"
(20 cm)
Ferrite core
(supplied)
Pin layout for PC input
terminal
1
678
3
9
45
10
1514131211
2