Filter
Top Products
41
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 56/62/72HM195
Selecting the menu language
You can choose from three different languages (English, French
and Spanish) for the on-screen display of menus and messages.
(The TV Guide On Screen
™
menus are in English, regardless of
the language selected in this menu.)
To select the menu language:
1. Press MENU and open the Preferences menu.
2. Highlight Menu Language and press •.
3. Press y or z to select your preferred menu language and
press ENTER.
Navigate
Select
Back Exit
CH RTN
EXIT
Home CH Setup
English
Français
Español
Favorite Channels
Closed Caption Mode
Off
Closed Caption Advanced
Input Labeling
Menu Language English
Preferences
4. Press EXIT to close the Preferences menu.
Configuring the antenna input
sources
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Navigate
Select
Back Exit
CH RTN
EXIT
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
Auto
2 Sec
15 min
HDMI 2 Audio
Slide Show Interval
AVHD Skip Time
Setup
3. Open the Terrestrial menu, highlight Input Configuration,
and press ENTER.
Note: The Terrestrial menu may not be accessible (items will
be “grayed out”) in some instances (for example, if a cable
box is connected to the ANT 1 input or if one of the VIDEO
modes is the current input during TV Guide On Screen™
setup).
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate
Select
Back Exit
CH RTN
EXIT
4. Press x or • to select the input source (Cable or Antenna)
for the ANT 1 input on the TV.
Note: If a cable box is connected to the ANT 1 input during
TV Guide On Screen™ setup, the entire Terrestrial menu will
not be accessible, including the input source for ANT 1, which
will automatically display “Cable Box.”
5. Press z and then x or • to select the input source (Cable
or antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
Input Configuration
Antenna 1 In
Antenna 2 In
Cable
Antenna
Cancel
Done
6. To save your new settings, highlight Done and press
ENTER. To revert to your original settings, highlight
Cancel and press ENTER.
Setting up your TV
6
For menu navigation instructions, see Chapter 4.
#01E_041-043_566272HM195 7/28/05, 4:27 PM41
Black