Filter
Top Products
27
Set up
Preparation
Basic Operation
Advanced Operation
Reference Selection
2
If you want to watch the blocked program temporarily,
press MUTE.
Press the Number
buttons (0-9) to enter the
4-digit code you have
stored.
If the number is correct, the
block mode will be
released.
After 1 second, normal
picture will appear.
ENABLE BLOCKING : [Y]N
SET RATING
SET BLOCKING OPTIONS
NEW PIN CODE
BLOCK CHANNEL
MOVE[s t ] SELECT[T S ]
2
Select “BLOCK
CHANNEL” in the V-CHIP
CONTROL menu by
pressing t or s.
BLOCK CHANNEL
[SET]CLEAR
0 0 0 0
SELECT[T S ] SET[s t ]
END[EXIT]
BLOCK CHANNEL
[SET]CLEAR
0 0 0 2
SELECT[T S ] SET[s t ]
END[EXIT]
3
Press T or S to display the
BLOCK CHANNEL menu.
4
Press T or S to select
“SET”, then press t or s
until the channel number to
be blocked (“2” in this
example) replaces “0” on
the display.
THIS PROGRAM HAS BEEN BLOCKED
TV–PG L V
EXCEEDS SET LIMITS
PUSH MUTE TO ENTER PIN
CABLE 4
BLOCKING IS ACTIVE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~–
SELECT[0-9] END[EXIT]
INCORRECT PIN CODE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~~
SELECT[0-9] END[EXIT]
All blocking is disabled until the TV is turned off.
It will be enabled when the power is reapplied.
If a wrong pin code is
entered, the message
appears.
Enter the correct code
again.
Unblocking programs temporarily
1
If you try to watch a TV program that exceeds the rating
limits you set, the TV will enter into the program block
mode.
BLOCK CHANNEL function
With the CHANNEL BLOCK function, you can block
specific channels. The TV will not be able to tune these
channels with the CHANNEL s/t buttons or Channel
Number buttons, unless you clear the setting.
This TV has 8 memory spaces total, 4 for TV mode and 4
for CABLE mode.
To block channels
1
Select a channel you want to block.
5
Repeat steps 1 to 4 for other channels.
6
Select another channel before turning off the TV.
To restore channels
1
Select “CLEAR” following the
above steps 2 to 4.
2
Press t or s until “0”
replaces the channel
numbers.
3
Press EXIT to erase the display.
BLOCK CHANNEL
SET [CLEAR]
15 10 6 2
SELECT[T S ] CLEAR[s t ]
END[EXIT]
0 0 0 0