Filter
Top Products
8
Reference Selection
Advanced Operation
Basic Operation
Set up
Preparation
Programming the Remote Control
●
This Remote Control is preprogrammed to operate TOSHIBA VCR’s.
●
To use VCR’s other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
FF
SLOW
PAUSE
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
RECALL
Number
To control other brands of VCR’s and cable TV converters
1
Refer to the “
VCR code table
” (or “
Cable TV converter code
table
”) on pages 9 and 10 to find the code number that corresponds to the
brand name of your VCR (or converter).
If more than one number is listed, try each one separately until you find
the one that works.
2
Set the TV/CABLE/VCR switch to “VCR” (or “CABLE”).
3
Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
4
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
–
If the right number was entered, the VCR (or the converter) should
turn off.
–
If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another code number.
For future reference, write down the code numbers you used:
VCR CODE
CABLE CODE
Notes:
●
You have to reprogram the Remote Control when you change its batteries.
●
Some newer VCR’s are capable of working on either of two remote codes. These
VCR’s have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch, and does not respond to all the code numbers
for your VCR brand name, set the switch to another position (“VCR1” or “VCR2”)
and reprogram the Remote Control.