Toshiba 32A60 CRT Television User Manual


 
21
Reference
Welcome to
Toshiba
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TVs
Features
Appendix
Index
7. Repeat steps 1 through 7 to block other channels. When you are
finished blocking channels, press EXIT to return to normal
viewing.
If you try to display a blocked channel, the TV will not display it, but
will display the nearest unblocked channel.
To unblock channels:
1. Press MENU, then press
x or to highlight the SET UP menu.
2. Press
y or z to highlight V-CHIP and then press x or to
display the V-CHIP menu.
3. Use the Channel Number buttons (0-9) to enter your PIN code.
If you are accessing the V-Chip menus for the first time, choose a
four-digit number to be your PIN code. Wait 2 seconds for the
BLOCKING menu to appear.
4. Press
y or z to highlight BLOCK CHANNEL and then press
x or to display the BLOCK CHANNEL menu.
5. Press
x or to highlight CLEAR and clear all channels from the
list of blocked channels. Press
y or z.
6. Press EXIT to return to normal viewing.
Video Lock
Video locks allow the user to lock out the input sources (Video 1,
Video 2, ColorStream) and channels 3 and 4.
The possible options are listed below:
Video: This option blocks out Video 1, Video 2 and ColorStream
Video+: This option blocks out Video 1, Video 2, ColorStream,
channels 3 and 4
Off: Disables the video lock feature
Note: In normal TV viewing, if you cannot access the input
sources (Video 1, Video 2, Video 3, ColorStream, Channel
3 or 4) please check that this feature has been disabled.
To setup the video lock, follow the steps below:
1. Press the MENU button. Press
x or to select SETUP.
2. Press
y or z to select the “V-Chip Control” menu item.
BLOCKING IS ACTIVE
PIN CODE
- - - -
AUDIO
PREFER
SET UP
C.CAPT
SELECT [0-9] END[EXIT]
PICTURE
3. Press x or to activate the menu. At the prompt, enter the
correct pin code number to access the V-Chip control menu. See
the section on “V-Chip control” on steps for entering the pin
code number. (pag e16)
4. If the correct pin code has been entered, press
y or z to select the
menu item “Video Lock.”
Note:
After programming BLOCK CHANNEL,
change channels before turning off the
television.
CH RTN
CH
VOL VOL
CH
EXIT
MUTERECALL
POWER
Channel
Number
ENT
1
4
7
2
5
8
3
6
9
0
100
TV
CABLE
VCR
MENU/
ENTER
Menu/Enter
Exit