Filter
Top Products
43
ADDITIONAL INFORMATION
Setting Control Codes
1
Press
TV
to set the remote control operating your TV.
2
While holding down
PROG.
, enter
the two digits of your TV’s brand
code (listed on page 44) using
number buttons
.
3
Release
PROG.
.
4
Point the remote control at your TV and use each button listed
below to make sure that your TV is operated correctly.
POWER
To turn the TV on or off.
CH/TRK
To select TV channels in the upper or lower
direction.
TV VOL
To adjust the sound level.
I.SELECT
To select an external source such as a VCR.
Number buttons
To select TV channels. When selecting channels
1 to 9, first enter 0 and then the desired number.
100
To substitute for 100 channel key.
DISPLAY
To turn on or off TV’s screen display.
ENTER
To use for the TV’s ENTER key.
Important
Some TVs may not respond to all the operations above, or
may not be operated at all with this remote control. In this
case, operate your TV with its own remote control.
Notes
• For some brands, several control codes (brand codes) are allocated. Try
each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code again.
Multi Brand Remote Control
The remote control can be compatible with various brands of TV by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
ADDITIONAL INFORMATION
Hold down.
Example
Number
buttons
2
0
PROG.
78
0
100
9
65
23
4
1
STOP
PLAY/x2
FFREW
100
ENTER
POWER
CH/TRK
TV VOL
DISPLAY
I.SELEC
T
1
2, 3
(Continued)