Filter
Top Products
32339AC 71
PAN / TILT / ZOOM
PAN /TILT / ZOOM OVERVIEW
The PTZ controls within the recorder allow you to control PTZ cameras without accessing them directly. This can increase the usefulness
of your recorded video. Using the PTZ controls, you can create custom preset configurations that can continuously sweep across large
areas.
Note These instructions are for use with Analog PTZ cameras only. For IP PTZ cameras, please refer to the PTZ Camera Setup section
of this manual.
Note PTZ setup and control is only available for supported video
encoders with a PTZ RS-485 pass-through.
Basic PTZ Configuration
1. On the Live screen, click Setup, and then click
PTZ Setup.
2. Select a PTZ-enabled camera from the Select
Channel list.
3. Select Enable Pan Tilt Connection.
4. Click Select Protocol and select the appropriate
protocol for your PTZ camera. For information on
the protocol used by your PTZ camera, refer to
your camera manual.
5. Set the appropriate Port, Baud Rate, Parity, Data Bits, and Stop Bits. These settings must match those of your PTZ
camera. For more information, refer to your camera manual.
6. Click Apply to save your settings.