Filter
Top Products
TRIAX DVB 75SI
16
'DLO\RSHUDWLRQ
This section describes the satellite receiver functions which you will
need every day, and which can be operated via your remote control.
2Q2IIVWDQGE\
When your satellite receiver has been connected to the wall socket
(and the electric current has been switched on), you may switch the
satellite receiver on and off by pressing the
[standby]
button of the
satellite receiver. The
[standby]
button on the front panel has the
same function.
You can also switch on the receiver by pressing one of the four
coloured buttons which will switch on the receiver and the
corresponding favourite list (programme list). As a starting point, the
four favourite lists of the receiver are as follows:
[red]
button =
Danish programme list,
[yellow]
button = Swedish programme list,
[blue]
button = Norwegian programme list and
[green]
button =
Basic list.
When the receiver has been switched on once via a coloured button,
it will remember the setting and the programme list which will be then
active until another coloured button is used to switch on the receiver.
You should only switch off the satellite receiver entirely (and/or
remove the plug from the wall socket) if you are not going to use the
satellite receiver for a long time (e.g. during holidays). However,
smart card updating will only take place when the receiver is
switched on.
NOTE:
The automatic update functions of the satellite receiver are
only active when the satellite receiver is in standby mode. Therefore
the satellite receiver will automatically go into standby mode after 12
hours if no remote control button has been pressed during that
period. You can change or delete the period of this ”floating sleep-
timer” in the main menu (See chapter 4 ’Settings').
&KDQJHRIFKDQQHOV
In the following description of methods for change of channels we
anticipate that only a normal TV picture from a chosen channel is
displayed, and that no system or submenus are displayed on the
screen. The satellite receiver stores the channel chosen last and
automatically starts on this channel when switched on again after
having been switched off (or put in stand-by mode).
4XLFNFKDQJHRIFKDQQHOVYLDWKHUHPRWHFRQWURO
Your satellite receiver contains a pre-programmed programme list.
In chapter 4 ”Settings” you can read how to change this or another
one of the programme lists at your own option.
OK
S
ection of a remote
c
ontrol with standb
y
b
utton and four
a
rrow/coloured
b
uttons.