Uniden TL42WRA-B Flat Panel Television User Manual


 
Notes on Use
Recommendations
Power Supply/Voltage
Use only the specied power supply (230-240
VAC, 50 Hz). Use of other power supplies
may cause a malfunction.
• Be sure to use the power cord provided.
Antennas
To prevent the inuence of radio interference,
set up the antenna away from busy roads,
overhead railway lines, electricity feeder
lines, and neon signs. This is also effective
in preventing accidents from electric shock in
the event that the antenna falls over.
• Do not unnecessarily lengthen or bundle the
antenna wire. Doing so may disrupt recep-
tion.
Bear in mind to periodically inspect and
replace the antenna, if necessary, as it is
exposed to the wind and rain. The antenna
is particularly susceptible to damage in loca-
tions subject to smoke and soot or locations
exposed to sea breezes. If video reception
is poor, contact your dealer.
Installation
Do not install this product near equipment
that generates heat.
• Do not place objects on top of this product.
Do not place this product on unstable
surfaces or in locations subject to
moisture.
When this product is installed next to a
window, prevent it from being splashed by
This product cannot be used outside the
country of purchase, Australia or New
Zealand.
• This product can be used only in the coun-
try of purchase, Australia or New Zealand.
It cannot be used in any other country as
broadcasting systems and power voltages
differ overseas.
INTRODUCTION
8
230-240V