Filter
Top Products
23
PROGRAMMING CHANNEL CONTROL LOCK
By default,the remote control’s channel-control capabilities
are locked to the cable converter. The affected keys* are
0~9,CH+,CH-,ENTER,and LAST.This will guarantee that
you do not inadvertently change a channel on your TV or
VCR.However,you can de-activate this feature to allow full
access to these keys in the TV and VCR modes.
*NOTE: This feature does not affect the AUD mode.
To De-Activate Channel Control Lock:
1. On the remote control,press CBL once.
Then press and hold SETUP until the
CBL key blinks twice,then release SETUP.
2. Enter 9 - 7 - 3.
3. Press CH- once. The CBL key will blink
four times.
4. Now,the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.
To Re-Activate Channel Control Lock:
1. On the remote control,press CBL once.
Then press and hold SETUP until the
CBL key blinks twice,then release SETUP.
2. Enter 9 - 7 - 3.
3. Press CH+ once. The CBL key will blink twice.
4. Now,regardless of what mode you select
(i.e.,TV,VCR,or CBL),only the channel
control capability of your cable converter will
be accessible.
Atlas Manual 4/8/02 9:37 AM Page 23