Filter
Top Products
NOTE: If the selected mode key emits a long blink,the
code is invalid.Repeat steps 2 through 3 and try
entering the same code again.
4. Aim the remote control at the device and press
POWER once.The device should turn off. If it
does not,repeat steps 2-3,trying each code for
your brand until you find one that works.If it
still does not work,try searching for the code
(see Searching For Your Code on page 20).
NOTE: If the device does not have a POWERkey, press
the (Play) key.
5. Repeat steps 1 through 4 for each device you
want the the remote control to control. For
future reference, write down each working
device code in the following boxes:
AUD
Audio Device ____________________
VCR
TV
CBL
PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo,perform the following
instructions to control this device:
1. Turn on your TV/VCR Combo and insert a
video cassette.
2. On the remote control,press VCR once.
Press and hold SETUP until the VCR key
blinks twice,then release SETUP.
3. Use the Setup Codes For TV/VCR Combos (on
page 19) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo.If you perform this procedure correctly,
the VCR key will blink twice.
continued on next page...
9
Atlas Manual 4/8/02 9:37 AM Page 9