Filter
Top Products
24
USING THE MASTER POWER KEY
The Atlas Universal Remote Control has a unique feature
that allows you to sequentially turn on or off all of your
home entertainment devices with a single key press.
To Program The Master Power Key:
1. On the remote control,press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9 - 9 - 5.
3. For the first device you want in the power on
sequence,press a device key (e.g.,CBL) once
and then press POWER once.
4. Repeat step 3 up to three more times to add the
second,third,and fourth device,as desired.
5. To save the settings and exit the program,press
and hold SETUP until the CBL key blinks twice,
then release SETUP.
To Clear The Master Power Key:
1. Perform steps 1 and 2 in the above section.
2. Press POWER once.
3. To clear the settings and exit the program,press
and hold SETUP until the CBL key blinks twice,
then release SETUP.
To Operate The Master Power Key:
1. After programming,point the remote control
at the devices.Press CBL once.
2. Press MASTER POWER once to sequentially turn
on or off all home entertainment devices.
NOTE: MASTER POWER only works in the CBL mode.
If it is not programmed,only the cable converter will
turn on or off.In any other mode,pressing MASTER
POWER once will turn on or off the selected device.
3. You will see the devices turn on or off
according to the programmed sequence.
Atlas Manual 4/8/02 9:37 AM Page 24