Filter
Top Products
www.urcsupport.com/atlasocap
16
the key on the original remote until the Atlas
OCAP 5-Device Remote Control with
Learning’s LED blinks twice.
NOTE: If the LED displays one long blink, a learning
error has occurred. Try repeating this step
again until a successful capture occurs. If the
function is still not captured, press and hold
SETUP to exit programming and review the
“Learning Precautions” on the previous page.
If needed, also see “Troubleshooting” on
page 25. After review, start programming
again at step 1.
Deleting a Single Learning Key
T
his process returns the key to its original programmin
g
for the mode you select. You can also delete learned
programming by teaching a different function to the key
(see “Programming a Learned Key” on page 15)
NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
3. Press the key containing the learned function
to be deleted twice. The remote will blink
twice.
6. Repeat steps 2 through 5 for another mode
and/or key or press and hold SETUP to exit
programming.
1. Press and hold SETUP until the last-selected
mode key blinks twice, then press 9 7 6.
2. Press a mode key once (i.e., VCR, DVD, AUD,
TV, or CBL).
4. Repeat steps 2 through 3 for another key or
press and hold SETUP to exit programming.
Atlas OCAP M1056L.fm Page 16 Friday, December 22, 2006 6:10 PM