Filter
Top Products
www.urcsupport.com/atlasocap
23
Using the Master Power Key
You will see the devices turn on or off according to the
programmed sequence.
Clearing the Master Power Key
RE-ASSIGNING DEVICE KEYS
The Atlas OCAP 5-Device Remote Control with Learning
can be set up to control a second device of an already-
assigned type. For example, to have the unit control a
TV, a Cable Converter, and two audio devices (for
example, two audio receivers), re-assign the unused VCR
key to operate the second audio device as follows:
NOTE: VCR is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
1. After programming, point the remote control
at the devices. Press CBL once.
2.
Press
PWR
once to sequentially turn the
programmed home entertainment devices on
or off.
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press and release PWR.
4. Press and hold SETUP until the CBL key blinks
twice.
1. On the remote control, press VCR once; it will
blink once. Then press and hold SETUP until
the VCR key blinks twice.
2. Enter 9 9 2. The VCR key will blink twice.
Atlas OCAP M1056L.fm Page 23 Friday, December 22, 2006 6:10 PM