Filter
Top Products
27
PROGRAMMING ID LOCK
The Atlas DVR/PVR 5-Device Universal Remote Control
is locked at the factory to operate a Scientific Atlanta
cable converter.However,if you have another brand or
model of cable converter or satellite service that you
would like to control, then you’ll need to perform the fol-
lowing steps to unlock the ID Lock,enter in a new manu-
facturer’s code,and lock the ID Lock again.
1. Turn on the cable converter.
2. On the remote control,press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
3. Enter 9 - 8 - 2.The CBL key will blink
four times, indicating ID Lock is unlocked.
4. Perform the instructions in Programming
Device Control on page 10 to program device
control for the desired cable converter or
satellite receiver.Upon completion,perform
the remaining steps (5 and 6 on this page) to
again lock the ID Lock.
5. On the remote control,press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
6. Enter 9 - 8 - 2.The CBL key will blink twice,
indicating ID Lock is again locked.
PROGRAMMING “TUNE-IN” KEYS
FOR SPECIFIC CHANNELS
The Atlas DVR/PVR 5-Device Universal Remote Control
includes three “Tune-In”keys (located directly below the
MUTE and LAST keys).Each can be programmed to
remember three of your favorite cable channel settings
for a total of nine channels.If you want to change the
cable channels in a previously-programmed “Tune-In”
key,you’ll need to clear the key first (see next page).
continued on next page...
Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 27