Universal Electronics DVR/PVR 5 Universal Remote User Manual


 
29
USING THE MASTER POWER KEY
The Atlas DVR/PVR 5-Device Universal Remote Control
has a unique feature that allows you to sequentially turn
on or off up to five of your home entertainment devices
with a single key press.
To Program The Master Power Key:
1. On the remote control,press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9 - 9 - 5.The last-selected device key
will blink twice.Then press PWR once.
3. For the first device you want in the power on
sequence,press a device key (e.g.,CBL) once .
4. Repeat step 3 up to four more times to add the
second,third,fourth,and fifth device,as desired.
5. To save the settings and exit the program, press
and hold SETUP until the last-selected device
key blinks twice, then release SETUP.
To Operate The Master Power Key:
NOTE: If MASTER POWERis not programmed,pressing it will only
command the last-selected device to power on or off.
1. After programming,point the remote control
at the devices.
2. Press and hold PWR for at least 2 seconds.
You will see the devices power on or off
according to the programmed sequence.
To Clear The Master Power Key:
1. Perform steps 1 and 2 in the first section
above, To Program The Master Power Key.
2. To clear the settings and exit the program,
press and hold SETUP until the last-selected
device key blinks twice,then release SETUP.
Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 29