Filter
Top Products
PROGRAMMING TV/VCR COMBO CONTROL
Locate the brand name of your TV/VCR Combo in the
Setup Codes For TV/VCR Combos section below, and write
it in the following space.
TV/VCR Combo Brand: ________________________
The brands are listed in alphabetical order with popular
codes listed first.You will use one of these codes to pro-
gram the Millennium 3 to operate your TV/VCR Combo:
1. Turn on your TV/VCR Combo and insert a
video cassette.
2. On the Millennium 3,press VCR once.Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your TV/VCR
Combo.If you perform this procedure correct-
ly,the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit,then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 3 at your TV/VCR Combo
and press VCR once.The unit should turn off.If
it does not respond,repeat steps 2-3,trying
each code listed for your brand until you find
one that works.If it still does not work,try
searching for the code (see Searching For Your
Code on page 22).
5. If you’ve located a TV/VCR setup code that
works your TV/VCR Combo and a separate
TV code is also listed,you’ll need to program
this code into the Millennium 3 to access vol-
ume control (see Programming TV Control on
page 8).
If there is no separate TV code listed,you will
need to perform the following steps to access
volume control:
a. Press and hold SETUP until the LED blinks
twice,then release SETUP.
b. Enter 9 - 9 - 3.The LED will blink twice.
c. Press VCR once.The LED will blink twice.
16
Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 16