Filter
Top Products
CHECKING THE CODES
If you have set up the Millennium 3 using the Searching
For Your Code procedure,you may need to find out which
four-digit code is operating your equipment:
For example,to find out which code is operating your TV:
1. Turn on your TV.
2. On the Millennium 3,press and hold SETUP
until the LED blinks twice,then release SETUP.
3. Enter 9 - 9 - 0.The LED will blink twice.
4. To view the code for the first digit,press 1 once.
Wait 3 seconds and count the number of LED
blinks (e.g.,3 blinks = 3) and write down the
number in the leftmost TV Code box below.
NOTE: If a code digit is “0”,the LED will not blink.
5. Repeat step 4 three more times for remaining
digits.Use 2 for the second digit,3for the third
digit,and 4for the fourth digit.Finish writing
down the code in the TV Code boxes below.
6. To check for the codes of other components,
repeat steps 1 through 5,but substitute the
appropriate key (i.e.,VCR or CBL) for the (VCR
or Cable) component you are checking.Write
down the codes in the appropriate boxes below.
TV Code
VCR Code
CABLE Code
23
Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 23