Filter
Top Products
PPaaggee 99
MMRRFF--220000 BB
AASSEE
SS
TTAATTIIOONN
SStteepp 33 -- CCooppyy TThhee PPrrooggrraammmmeedd DDeevviiccee
In tree view, right click on the device you programmed.
From the context menu that appears, select COPY.
SStteepp 44 -- PPaassttee TThhee PPrrooggrraammmmeedd DDeevviiccee
In tree view, right click on the first device that is NOT
PROGRAMMED. From the context menu that appears,
select PASTE.
Repeat this PASTE on all of the other identical device.
Save your work.
SStteepp 55 -- OOppeenn tthhee RRFF SSeettuupp WWiinnddooww
The RF Setup window opens after selecting RF
Control from the Program Menu.
The RF Setup window is composed of a “spread sheet” of options for EACH
of your devices. By looking at the Signal column, you can see that the factory
default programming sets all of the devices to send both IR and RF commands.
If you look at the column for Flashers, you can see that the default sends IR
commands for all devices to ALL of the flashers. Both options must be
changed for identical components.Additionally, if you are not using it, you may
wish to disable the Front Blaster (see page 7 for directions).
SStteepp 66 -- AAddjjuusstt tthhee SSiiggnnaall FFoorr EEaacchh ooff tthhee IIddeennttiiccaall DDeevviicceess
The RF Setup window enables you to adjust the Signal output by the MX-800
for each device individually, by clicking on the intersection of a row and a col-
umn and then selecting
RRFF
from the three options shown in the pull down list
box .