Filter
Top Products
P
age 2
MRF-260 BASE STATION
Features and Benefits
Interference Rejection and Extended Range via Narrow Band
The MRF-260 receives RF (radio frequency) signals via its integrated
RF receiver and antenna. The MRF-260 displays RF interference via a
bright red Status LED, which flickers when interference is present if the
ID is set to 0. Simply relocate the MRF-260 should interference occur.
Two Fixed IR Outputs
The MRF-260 is equipped with two fixed IR line outputs with standard
3.5 jacks for standard IR emitter/flashers.
Two Variable IR Outputs Match Rear Panel IR Inputs
The MRF-260 is equipped with two adjustable IR line outputs. Each
output can be individually matched to rear panel IR inputs on any
component that is designed to be operated by a standard IR repeater.
The outputs utilize a 3.5mm jack and are compatible with standard IR
emitter/flashers as well.
Up To Fifteen Equipment Locations With Identical Components
Each MX/TX remote is “addressable.” They can be programmed to
specifically control components in a particular room by installing an
MRF-260 base station at eac
h location. In operation it’s simple: when
you select a device located in the Den, the MX/TX remote only sends
commands to the Den. When you select a device located in the
Family Room, the MX/TX remote only sends commands to it.
A Single MRF-260 Can Control an Array of Identical Components
or Identical Zones of a Multi Zone Preamp/Matrix Switcher
Each MRF-260 has four “addressable” IR Line Outputs. For example,
you can control up to four identical TV’s with one MRF-260 or route
volume commands for a specific zone to a particular zone IR input on
a multi-zone preamp. If you have more than four identical compo-
nents or zones, up to 15 additional MRF-260s can be installed to con-
trol them (thus allowing up to 60 identical components or zones in
one house).
Parts Guide
The MRF-260 RF Base Station includes:
1 - MRF-260 Base Station
1 - Mounting Plate for wall mounting
the MRF-260
4 - Screws for wall mounting
1 - 9V-300mA Power Supply
4 - Visible Flashers with 10 foot plug in
cables.
4 -
Extra self adhesive pads for
Emitters
12 - Labels for IR Line Outputs
1 - Screwdri
ver for Variable Outputs