Filter
Top Products
P
age 3
Installation
1. Unplug the MRF-260. Test all IR commands and macros line of
sight.
2. Power on all AV components including the TV. Turn on all of the
lights and lower all dimmers to 50%. Power on anything that
may create RF Interference (particularly devices with high speed
microprocessors or hard drives).
3. Check that the address wheel on the rear of the MRF-260 is set
to ID#0 (the interference “sniffing” position).
4. Connect the MRF-260 to its DC wall adapter and plug the wall
adapter into a live AC outlet. Place the MRF-260 in a location at
least 3 feet away from satellite receivers, cable boxes, HDTV
tuners, DVRs, PCs or any other device with a high speed micro-
processor (these generate broad band Radio Frequency
Interference -RFI). Of course, you should keep in mind that the
emitter cables are 10’ long.
MRF-260 BASE STATION
Check that the arrow pointer in the center of the wheel is pointed to 0, the
default “interference sniffing” position. If it is not, use a small flat blade
screwdriver (included) to set the RF ID# to 0.
The green POWER LED indi-
cates that the MRF-260 is
powered on.
The red STATUS LED flashes
differently, based on the
Address setting:
IF SET TO ID#0
The Status LED flashes
w
hen it receives ANY RF
signal, including RFI. This
makes ID#0 ideal for “sniff-
ing” out RFI.
IF SET TO ANY OTHER ID#
The Status LED flashes ONLY
w
hen it recei
v
es a correctly
addressed RF
command.