Universal Remote Control MRF-260 Universal Remote User Manual


 
P
age 4
5. Observe the Status LED of the MRF-260. If it is glowing or flick-
ering you must relocate the MRF-260 to a location where the
LED doesn’t flicker.
If your installation location simply doesn’t offer you any choice
and you are detecting interference everywhere you place the
MRF-260, you have two last resort options:
a. Remove the MRF-260’s antenna. This will reduce the
range enormously, but may still be enough for this client.
b. Admit defeat and install the two piece MRF-350 base
station, which can have the RF Antenna module remote-
ly located (even in another part of the house).
7. Once you have found a location that is absolutely free of RFI
with everything on, test to see if the range is ade-
quate and that macro reliability is perfect. Start
with the antenna angle set to 45 degrees and posi-
tioned so that the long side of the antenna is fac-
ing the customer’s favorite seating position.
When testing, set both the remote and the MRF-260 to the same
valid RF ID#. Keep in mind that zero (0) is not a v
alid RF ID#.
Watch the Status LED on MRF-260 - it should light every time
you press a button on the remote. This confirms that the signal
was received and understood perfectly. If you repeat any button
press multiple times and the Status LED lights correctly every
time, you have no interference and a very reliable installation. If
some of the presses do not light the Status LED, you still have
some RFI. Your best strategy is return to step 3 and try to find a
better location for the MRF-260.
8. Now that the location is fixed, connect each of the emitters to
the appropriate IR output and run the cable to the appropriate
component. Do not attach the emitters to the front panel yet!
Utilize the included preprinted labels to identify which emitter
goes to which component. If you’d like to make your own, the
slots for the labels have been sized at 12mm to enable a Brother
P-Touch 12mm label to fit perfectly.
NOTE: TiVo, Replay TV, other DVRs, Satellite Receivers and Cable
Boxes are all extremely sensitive to IR overload or saturation. For
this reason, it is recommended that you always connect the IR
flashers for these types of component to the Variable IR Outputs of
the MRF-260.
MRF-260 BASE ST
ATION
45°