Filter
Top Products
SETTING UP FOR TV, VCR, CABLE BOX AND SATELLITE RECEIVER
1. Turn on the device you want to control (TV,
VCR, cable box, satellite receiver etc.).
2. Press and hold SETUP until the LED
indicator lights steadily. Release the SETUP
button.
3. Press and release mode button for the
device you want to control. The LED blinks
once. Use AUX1 or AUX2 for CD
equipment.
4. Enter the 3 digit Code from the Code List
(separate sheet). The LED turns off after
the last digit entered.
5. Point the remote at the device and press
the POWER button. Your device should
turn off.
6. Turn your device on and press CHANNEL+.
If the device responds, setup is complete.
NOTES:
For CD players use the AUX 1 or AUX 2 buttons.
If your TV/VCR/Cable Box/Satellite Receiver does not
respond, try the other codes for your brand. If it still doesn’t
respond, try the Code Search method on page 10.
If the LED blinked rapidly when you entered the code, you
may have entered an invalid code. Recheck the code in
the code list (separate sheet) and try again.
If some buttons do not operate your equipment, try one of
the other codes for your brand.
8
DI-000-HCCUR-00A 7/5/02, 2:19 PM8