Filter
Top Products
Repeat Steps 4 through 7 for any other buttons you wish to
learn new functions.
8 Once you have completed the learning for all the desired
buttons in a Device mode, store the learned functions by
pressing the Device and SEL/PLAY buttons simultane-
ously, once again. The LCD in the SL-9000 will show
SAVED and then return to the Device Mode. The
remote has now returned to the original operating mode.
Once you have stored the learned functions, test the but-
tons that have been taught. If any of the buttons do not
operate as they should, please repeat from Step 1 for those
buttons.
Note: If the LCD shows FAIL at any time during the learning
process, the SL-9000 was unable to learn the new functions.
Please repeat from Step 4. If the SL-9000 continues to
show
FAIL during the learning process, please try the following
suggestions:
* Increase or decrease the head to head distance between the two
remote controls, within a 1 to 5 inch range.
* Increase or decrease the time you press and hold the button on
the original remote control in step 5, for 1 to 2 seconds.
* Avoid fluorescent lights or strong sunlight during the set up.
These lighting conditions can cause interference with the learning
process.
* Verify that the original remote control contains fresh batteries.
Some remote controls operate at non-standard IR, UHF or
ultrasonic frequencies, and are unable to be learned. If you
continue to experience difficulty during set up, please
contact our customer service department for assistance.
15
15
Using Your Remote