Filter
Top Products
Learning New Functions on Device Buttons
The eight Device buttons at the top of the remote control
can also learn new functions. These buttons can only learn
when the SL-9000 remote is in the corresponding Device
mode, e.g. AUDIO, VCR, TV etc.
1 Place the SL-9000, and the original remote control to be
learned from, on a flat surface. Line up the remote
controls head-to-head about 2 to 3 inches apart.
2 Press the corresponding Device button so the Device name
appears in the LCD. E.g. AUDIO, VCR, TV etc.
3 Press and hold the Device button and SEL/PLAY buttons
simultaneously, until LEARN appears in the LCD.
The SL-9000 is now ready to learn.
Note: Each of the following steps must be completed with-
in 20 seconds. If the remote does not receive any com-
mands within this allotted time, it will return to its normal
operating mode.
4 Press the Device button selected in Step 2. once again.
READY will appear in the LCD
5 Press and hold the button on the original control you
would like to teach into the SL-9000 for about three
seconds. (----) will appear in the LCD.
6 Release the button on the original remote. RETRY will
appear in the LCD.
7 Press and hold the same button on the original remote,
once again. The LCD on the SL-9000 will flash GOOD,
the DEVICE Mode and then return to LEARN, verifying
that the new function has been learned.
16
16
Using Your Remote