Filter
Top Products
ViewSonic N2752w
20
ENGLISH
When you enter this control, the screen below will be displayed.
The factory default of the password is “0000”.
To enable parental control, input the password, press ▼ button to focus on “ok” key, and
press
ENTER. (select Cancel if you want to exit)
After entering, the following screen will be shown.
Channel Lock: To lock channels. Use ◄► to select the channel you want to lock, and then
press
ENTER to lock or unlock it.
Change Password: To change the password, press ENTER and enter the password again.
Press
ENTER, and the following screen appears.
Enter the new password, use ▼ to move the cursor down, and then enter the new password
again, press
OK to confirm or Cancel to exit.
Note: Please make sure you remember your new password after changing. If the password
is forgotten or missing, please use the remote control to enter “8866” to clean the password
and reset a new one.
Clear All: To clear all the locks set before, press
ENTER.
Press MENU to return to the previous page.
•
Color Temperature: To select the color temperature from Warm, Cold, Normal or User.
(If you select User, you can adjust the degree of R, G, B in Color Temp. to suit your personal
preference.)
•
Back Light: To adjust the luminance of the back light.
•
Aspect Ratio: To select image size between Normal, Full, Wide1, Wide2, Wide3, 4:3, 16:9,
and No scale.
•
OSD Timeout: To setup the display time of OSD. (5, 15, 45, and 60 seconds)
•
Memory Recall: To restore the factory default settings.