Filter
Top Products
E
N
G
L
I
S
H
Device
Buttons
LED
Basic Setup
1 Power on the A/V component you wish to setup, so that you can test codes by
sending power off commands.
2 Refer to the Pre-programmed code tables on pages 2-3 and write down the code
number listed.
3 Press and hold the button for the desire device for approximately six seconds. The
top LED will turn on, enter pre-programmed code. LED will blink to indicate pre-
programmed code was captured code was captured correctly.
Pre-Programmed Code Notes
Record the three digit codes for your device here:
VPB
WMA
AUD
AUX
TV
DVD
STB
VCR
_________
_________
_________
_________
_________
_________
_________
_________
ViewSonic N3250w 11