Filter
Top Products
5
Introduction
Introduction
1. Front View
1. (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Red) Standby mode
Indicator on(Green) Power on mode
2. The functions of the buttons:
TV/AV: Press to display the input source menu.
MENU: Press to display the OSD menu,
press again to exit the menu.
CH+/-: Press to scan through channels.
VOL+/-: Press to adjust the volume.
POWER: Turn on/standby the TV set.
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
0
to the left or right side and 20
0
above or below the remote control
window.
Press TV/AV button on the TV set or remote control to
display the input source menu, and use CH+/- button on
the TV set or
∧
/
∨
button on remote control to select the
input source, press OK button on the remote control to
enter.
Note: Before you select the input source, make sure the
connections are prepared.
TV
AV
Component
HDMI
VGA
INPUT SOURCE
MENU CH- CH+ VOL- VOL+ TV/AV POWER
Led Indicator
Remote Control window
(Keep clear)