Viper G5102V Universal Remote User Manual


 
22
© 2008 Directed Electronics. All rights reserved.
High-Security Disarming
If you want the Full Alarm response to stop without unlocking the doors,
press the
A U X
button. The system will re-arm and the current alarm re-
sponse will reset.
System override
To disarm the system without a remote control:
You will need to use your Override Switch located
on your systems control center (see diagram to left)
to disarm the system. The Override Switch disarms
the system only if you have the vehicle key.
Open the door. The alarm will sound.
Immediately insert the key into the ignition and turn it to the RUN or ON
position. (all the indicators in the dash will turn on).
Press the Override Switch once.
Note: The Override Switch feature allows you to select a specific
number of presses needed to disarm the alarm. If the Override
Switch has been programmed to a new number of presses by your
authorized dealer, that number should be indicated below.
Override Switch Number ___________
Valet mode
To enter or exit valet mode with the valet/program switch:
Turn the ignition key on and then off.