Filter
Top Products
43
© 2008 Directed Electronics. All rights reserved.
Glossary of terms
Control Center:
The control center contains the system’s radio-frequency
antenna, the valet and override switch, and the Status LED.
For maximum remote-control range, the Control Center is usually lo-
cated at the top of the windshield, centered near the rear-view mirror.
Control Module:
The “brain” of your system. Usually hidden underneath
the dash area of the vehicle. It houses the microprocessor which moni-
tors your vehicle and controls all of the alarm’s Functions.
Failsafe® Starter Kill
(if equipped): An automatic switch controlled by
the security system which prevents the vehicle’s starter from cranking
whenever the system is armed. The vehicle is never prevented from
cranking when the system is disarmed, in Valet® Mode, or should the
starter kill switch itself fail. Your system is ready for this feature, however
installation of this feature may require additional labor.
Input:
Any physical connection to the security system. An input can
be provided through a sensor, pin-switch or by existing systems in the
vehicle, such as ignition or courtesy lights.
In-vehicle status LED:
A light used to indicate the status of your system.
It is located on your systems control center.
Shock Sensor:
This system has a dual zone shock sensor. This sensor is
mounted in the vehicle and designed to pick up impacts to the vehicle
or glass.
Trigger or Triggered Sequence:
This is what happens when the alarm
“goes off ” or “trips.” The triggered sequence of your system consists