Filter
Top Products
CONFIDENTIAL – DO NOT COPY
Page 7-54
File No. SG-0198
Read Command
Writes
Write bursts are initiated with a Write command, as shown in timing figure Write Command on
following: The starting column and bank addresses are provided with the Write command, and Auto
Precharge is either enabled or disabled for that access. If Auto Precharge is enabled, the row being
accessed is precharged at the completion of the burst. For the generic Write commands used in the
following illustrations, Auto Precharge is disabled.
During Write bursts, the first valid data-in element is registered on the first rising edge of DQS
following the write command, and subsequent data elements are registered on successive edges of
DQS. The Low state on DQS between the Write command and the first rising edge is known as the
write preamble; the Low state on DQS following the last data-in element is known as the write
postamble.