Vizio VO37L FHDTV10A Flat Panel Television User Manual


 
VIZIO VO37L FHDTV10A User Manual
Version 10/17/2008 49
www.VIZIO.com
Partial Channel Search
If you believe channels are missed from the auto
search, you can do a partial channel search to
look for channel in a certain channel range again.
Press the
button to highlight the Partial
Channel Search selection.
Press the
button to enter the submenu.
Press the
button to select scan mode to look
for Analog, Digital, or both Analog/Digital channels.
Press the
button to highlight the “To” and
“From” selection. Press the
button to select the
range of channel numbers you want to start
searching in.
Press
to start channel search.
Once the adjustments are completed press the LAST button repeatedly to exit the OSD completely.
Skip Channel
After the TV has stored all of the available DTV channels in memory you will find that some channels will
be too weak to watch comfortably or they may be channels you do not want to see. Select the channel
you wish to remove, press
and buttons to open the TV TUNER SETUP menu and then press the
button to highlight SKIP CHANNEL. Press the button to select this channel to be skipped when
using the CH+ or CH- button. You will still be able to select this channel using the number buttons on the
remote control.
MTS
This feature allows you, the user to select the different languages in which the signal provider or
broadcaster is transmitting the audio with the program you are watching. This signal is usually or in most
cases Spanish language.
Press the
button as many times as it takes to scroll down to this option and get it highlighted.
Press either
or button to go through the settings of this feature to make your selection.
Once the adjustments are completed press the LAST button repeatedly to exit the OSD completely.
Time Zone
Setting the correct Time Zone for your area will
ensure that the correct program times are shown
after pressing the GUIDE button on the remote
control.
Press the
button to highlight the Time Zone
selection.
Press the
or button to select your area.
Once the adjustments are completed press the
LAST button repeatedly to exit the OSD
completely.