Filter
Top Products
VIZIO VW26L HDTV10F User Manual
Chapter 3 Setting Up to Watch Television
3.1 Basic LCD HDTV Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the HDTV, and then plug the
power cord into an AC wall socket.
2. Connect Audio and Video Cables to the HDTV
(see pages 13 ~ 23 for detailed steps)
3. Turning Power On
Once all the components are connected, press the Power ON button on the side of the HDTV, or
press the Power ON (Red) button on the remote control.
4. Select Input Source
Select the Input Source for the HDTV by pressing the INPUT
button on the side of the TV or using the Input button on the
remote control. Pressing this button will cycle you through the
following options: TV, AV1, AV2, Component, RGB, HDMI1 and
HDMI2.
5. Using DTV and TV with an Antenna or Cable
At first power on, the HDTV will have the DTV/TV input selected
and will guide through some setup screens. If it is not the first
time the HDTV has been powered on, you will need to select TV
using the INPUT button on the remote control or the side of the
HDTV, or directly by pressing the TV button on the remote control,
and Auto Scan for the available TV channels.
Note: If you do not see this option within the OSD, you might have selected the wrong input in the
previous steps and you will need to repeat step 4 (above) to select the correct input source.
a. The screen will show the first
Initial Setup OSD panel.
Press the OK button on the
remote control.
b. The Language choice screen will
be displayed; the default English
option is highlighted. If you wish
to change the OSD language to
Français or Español, press the
button on the remote control to
select the language you want.
Press the button on the
remote to go to the next screen.
Version 9/20/2007 25
www.VIZIO.com