Filter
Top Products
www.wegener.com 800032-01 Rev. G 37
Unity 4600 User’s Manual
This command sets audio attenuation, where 0 gives 0dB attenuation (maximum level). A Local Control
Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
AUDIOMODES
Lists all the supported audio decompression or pass-through modes (e.g., MPEG1 Layer 2, Dolby AC-
3, MP3, SMPTE302, etc.)
AUDMON port#
port#: Either 1 or 2 for audio ports 1 or 2.
Connects a sample of audio port port# to the single audio monitor jack (where available). A Local Control
Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
AUXPID [PID]
PID: Selects the PID (in hex) for the transport packets carrying the desired data stream. Must be
20 to 1FFE inclusive. If PID is omitted, the current value is displayed.
Sets the PID used for Aux Data extraction.
CLRDIAG
Clears all the volatile counts and statistics, as if the unit was reset. A Local Control Command (available
from the terminal regardless of "Local Control Enable/Disable" commands from the
network).
CLRIND
Clears both current “Acknowledged” Alarm and Warning indications and (past) Latched Alarm
indications. A Local Control Command (available from the terminal regardless of "Local
Control Enable/Disable" commands from the network).
DELS entry
entry: Value from 1 up to max (given in section 2.1) indicating entry number in settings table.
Deletes an entry in the Preset Table.
DPAT
Command reports current Program Allocation Table (PAT) from incoming transport stream.
DPSI
Command reports complete PSI information tracing all programs and their components to MPEG PIDs.
A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
DTMFTST [level] [tone]
level: Integer between 0 and 100 inclusive.