Filter
Top Products
10
Parts/Specifications/Warranty
Electronics Specifications
Primary Power .............................+13.8 VDC
Power Consumption ..........................3 amps
Operating Temperature ......... -10° to +130°F
Humidity ....................... 90% noncondensing
Size .................. 4-1/2"W x 4-1/4"H x 1-3/4"D
Weight .....................................................1 lb.
Mount Specifications
Height Lowered.......................................... 8"
Height Raised .....................30" vertical max.
Roof space required ..........40"L x 20"W min.
Turning diameter clearance ..................... 33”
Antenna Movement................... 2 DC motors
Weight ................................................. 16 lbs.
Shipping Weight.................................. 20 lbs.
Carton ......... 27-3/4"L x 20-3/8"W x 10-3/4"D
Dish Specifications
Reflector Diameter .................... 46 cm (18")
Antenna height..................................... 53 cm
Antenna width ...................................... 49 cm
Gain at mid-range
11.2 GHz.............................. 33.22 dBi
12.1 GHz.............................. 33.89 dBi
12.6 GHz.............................. 34.23 dBi
Effective aperture................................. 46 cm
Aperture efficiency .................................. 73%
Cross polarization (on axis)... ..............-21 dB
Beamwidth at -3 dB ................................. 3.5
o
Beamwidth at -10 dB ............................... 7.0
0
F/D Ratio ................................................. 0.59
Frequency Range ................10.95-12.75GHz
Offset angle............................................... 24
0
Gauge .................. 22 gauge galvanized steel
Finish: ........ Textured thermoset powder coat
Parts included
18 “Reflector
Backup structure
Mount base/turret
Mount cover & bracket
Vent tube
Cable entry plate
Hardware
Cable
Interior wall plate control
Surface mount box
Tools needed for installation
Level
Tape measure
Electrical tape
Cutter
Phillips screwdriver
Electric or cordless drill
1/8” drill bit (for pilot holes)
7/16” wrench (for dish assembly)
5/16” socket/nut driver
1-1/2” hole saw (cable entry hole)
Sealant compatible with roof material (check
with your vehicle manufacturer for compatibility)