Filter
Top Products
Slide the crimped end of the front assembly boom into the open end
of the back assembly boom (Figure 4). Re-insert the screw into the
plastic block closest to the mast clamp, and secure with the flange nut.
Figure 4
Crimped End
Then, slip the phasing lines onto the threaded rivets near the reflector
brackets. Add a washer onto each rivet. Thread a small nut onto each
rivet. See Figure 5.
Figure 5
Screw
Insertion
Site
5
Unfold the elements on the two corner reflectors as in Figure 6. You
should hear the pieces click into place.
AfterBefore
Figure 6
Top View Side View
Reflector Bracket
Phasing
Lines
Phasing
Lines
Rivet
Front Assembly Back Assembly
Mast
Clamp
Corner Reflector