Filter
Top Products
6
Tighten the two flange nuts. See Figure 9.
Insert the open end of one corner reflector in-between the top of the
reflector brackets (Figure 7). (Elements should be on top.) Align the
holes in the brackets with the hole in the corner reflector. Insert a
large screw through the holes. Thread a small flange nut on the screw.
Figure 9
Screws
Figure 7
Reflector Brackets
Next, insert the open end of the second corner reflector in-between
the bottom of the reflector brackets (Figure 8). (Elements should be
on bottom.) Align the holes in the brackets with the hole in the corner
reflector. Insert a large screw through the holes. Thread a small flange
nut on the screw.
Figure 8
If you determined that you need the Low Band VHF Add-On Kit,
proceed with the steps on the next page. If you determined that you
do not need the Low Band VHF Add-On Kit (page 7), continue with
attaching the coax cable on page 9.