Filter
Top Products
10
Using a 7/16" wrench, attach the weather-protected F-connec-
tor to the feed-through coming from the dome. First,
hand-tighten the connector onto the feed-through until it seats
into the rubber seal. Using one 7/16" wrench to hold the center
of the feed-through, lightly tighten the F-connector to the
feed-through using the other 7/16" wrench. Repeat the above
step to attach F-connector on the 35’ cable to feed-through.
Fig 3.7
Attach the weather-protected power connector from the
antenna to the weather-protected power connector on the
35’section of wire. The power connector is directional. Align
wire colors and firmly push connector together until latch
snaps and secures.
Fig 3.8
All coax connections
must be finger tightened, then
given 1/4” turn with a 7/16”
wrench.
3.7 Route and connect the coax and wires
Determine the best location for the RG-6 coax and 16 gauge
power wires to enter the vehicle, and the location of the satellite
receiver and rocker switch. Drill ½“ hole in the roof for the coax
and power wires to enter the vehicle. Insert the ends of the 35’
section of RG-6 and 35’ section of 16 gauge power wire into the
hole. Be sure to insert the ends that do not have connectors on
them. Push coax and power wires into the vehicle.
Rev. 9/30/05