Winegard SK-1000 Satellite TV System User Manual


 
SM ExpressVu
Peaking...
SM ExpressVu
Searching...
Power Off?
Yes *No
SM ExpressVu
*Yes No
SM Password
0022
LG Mount
SM Mount*
Install Password
0000
Select Antenna*
Raise Antenna
SM ExpressVu*
Installation
Exit*
Select Antenna
Installation*
Exit
Enter User Menu?
*Yes No
WINEGARD COMPANY
POWER ON
SM ExpressVu
Success
Installation*
SM DTV Triple
SM ExpressVu
Ready: Multi-Sat
SM ExpressVu
*91 *82
2
TIP
If you want to turn off the
power to the antenna after
the antenna has locked onto
satellites, press “POWER” and
“SELECT” at the same time.
Before traveling, make sure to
press “POWER” and wait for the
antenna to start to power up; then
press “POWER” again to initiate
the stow sequence.
Operation for Bell TV Users
4. The interface box will ask for a
password. Press “ENTER” four
times to enter code “0000.”
6. Press the Select button until the
asterisk is next to “SM Mount,”
and then press “ENTER.”
5. Press the Enter button to choose
“Select Antenna.”
2. The interface will ask if you wish
to enter the user menu. Press the
Select button to choose “Yes,”
and then press the Enter button to
confirm the selection.
1. Press and hold “POWER” for two
seconds or until the TRAV’LER
interface displays “POWER ON.”
Then, press and hold “ENTER for
two seconds.
3. The user menu consists of four
choices: Search Mode, Diagnostics,
Installation, and Exit. Press
“SELECT” until the asterisk is next to
“Installation,” and press “ENTER.”
7. Enter code “0022” by pressing
the Select button to increase each
number. Press “ENTER.”
9. Press the Select button until the
asterisk is next to “Yes.” Press the
Enter button.
8. Press “SELECT” until the asterisk is
next to “SM ExpressVu.” Press the
Enter button.
10. The interface will display “in
progress” and then “Success.”
12. Press the Select button until the
asterisk is next to “Exit.” Press the
Enter button.
11. Press the Enter button. Press
“SELECT” until the asterisk is next
to “Installation.” Press “ENTER.”
13. The interface will ask if you want to
turn the power off. Choose “No” by
pressing the Enter button.
15. The TRAV’LER antenna will enter
the search routine as part of its
normal operation.
14. The interface will display the type
of satellite dish on the top line.
16. Upon finding a satellite, the
antenna will fine-tune or “peak” on
a signal.
17. The TRAV’LER antenna will lock
onto two different satellites: 82°
and 91°. The antenna will display
an asterisk for each satellite found.