Winegard SK-1000 Satellite TV System User Manual


 
1 2
3
3
Select option 1, “Installation.” Then,
select option 1 again to choose
Point Dish.”
Select “Check Switch.” Continue
with step 4 on the next page.
Press “Menu” on your remote. Select
option 6, “System Setup.”
DISH Receiver Setup
The following instructions assume that the TRAV’LER antenna has found and locked onto satellites 110°, 119°, and
129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface. The following instructions
are based on a ViP
®
211 receiver. If your receiver differs from the options shown below, you may need to consult your
receiver manual. The wording and display used in yoru receiver may differ slightly.
Check out online receiver setup guides for your antenna at www.winegard.com/receivers/setupguide.php.
Manual Operation
The TRAV’LER antenna is a versatile satellite antenna and can be manually set to find many different satellites individually.
This function is rarely used. The instructions assume that the antenna is already in the stowed position. Note: Diagnostics
and Installation menus are not required for normal operation and should only be entered by a trained professional.
2. The interface will ask if you wish
to enter the user menu. Press the
Select button to choose “Yes,”
and then press the Enter button to
confirm the selection.
1. Press and hold “POWER” for two
seconds or until the TRAV’LER
interface displays “POWER ON.”
Then, press and hold “ENTER for
two seconds.
3. The user menu consists of
four choices: Search Mode,
Diagnostics, Installation, and Exit.
Press the Enter button to choose
Search Mode.
WINEGARD COMPANY
POWER ON
Enter User Menu?
*Yes No
Search Mode*
Diagnostics
5. The interface will ask you to
confirm the change. Press
“SELECT” to move the asterisk
to “Yes.” Then, press “ENTER” to
confirm the selection.
The TRAV’LER interface will
then acknowledge which satellite
has been selected. Press the
Enter button.
4. In the Search menu, choose from
the following: Multi-Sat Mode
(normal search mode), Manual
110, Manual 119, Manual 129, Main
Menu (returns to the user menu)
or Exit (enters the search routine).
(Note: Manual 82 and 91 will be
options for Bell TV users.) Press
the Select button to cycle through
satellites until the asterisk is next to
the satellite you wish to find. Press
“ENTER” to confirm the selection.
6. The interface will ask if you want
to turn the power off. Press the
Enter button to choose “No” and
start a new search for your chosen
satellite. Press “SELECT” then
“ENTER” to choose “Yes” and turn
off the antenna.
The TRAV’LER antenna will remain
in manual mode until you select
“Multi-Sat Mode” again.
Multi-Sat Mode*
Manual 61
Manual ##
Selected
Power OFF?
*Yes No