Filter
Top Products
3
Tuning Antenna
STEP 1. Your receiver should indicate it is receiving a signal. To tune
your antenna for the best signal strength. SLOWLY move the antenna
left, then right, until you have found the position that gives the highest
signal strength. It is important to turn the antenna slowly. Because
the signal is digital, the receiver takes a few seconds to lock on.
STEP 2. Place rotation clamp in the LOCK position. This prevents an
tenna movement and loss of signal.
STEP 3. SLOWLY raise, then lower the antenna until you have peaked
the signal. You are now ready to watch satellite TV!
Lowering Antenna to Travel Position
STEP 1. Set rotation clamp to ROTATE position.
STEP 2. Rotate antenna until pointer on directional handle aligns with the
red screw on the rotation clamp.
STEP 3. Turn elevating crank counter clockwise in direction of DOWN
arrow until meeting resistance. The number of turns will vary according
to the elevation angle the antenna was set at.
STEP 4. Move rotation clamp to the LOCK position. Antenna is now
locked in travel position.
STEP 5. Snap elevation crank in place.
CAUTION! NEVER LOWER ANTENNA IN ANY POSITION
EXCEPT TRAVEL POSITION!
DO’S
1. Do check parking location for obstructions before raising antenna.
2. Do carefully raise, lower and rotate antenna. If difficult, check for cause.
3. Do rotate SLOWLY when searching for the satellite(s), and check fine tuning on TV
set to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle!
5. Activate programming by calling program provider for your receiver.
1. Don’t move RV/coach with the antenna in the UP position. This will VOID your
WARRANTY. This may also cause damage to your roof.
2. Don’t force elevating crank up or down. Check for cause of trouble.
3. Don’t rotate directional handle hard against stops.
4. Don’t apply paint over top of base plate or any where on lift.
5. Don’t apply sealant on gear housing.
DON’T’S