Filter
Top Products
SAFETY 5
PN - 59744 (12/14/01)
WARNING
56050-A
CRUSHING HAZARD
To avoid injury
or death:
Do not walk or work un-
derneath a raised loader.
Lower loader to ground
before leaving tractor
seat.
FALLING HAZARD
To avoid injury
or death:
Do not work from or
allow riders on loader or
its attachments.
WARNING
(Safety Decals continued from previous page)
56059-A
LOADER MOUNTING INSTRUCTIONS
Read Operator’s Manual instructions before proceding.
To Remove Loader
1. Park tractor on level surface with bucket flat on
ground.
2. Dump bucket to take weight off mount pins and
allow for stand installation. Set brake and shut off
tractor.
3. Remove stands fromcrosstube andpin intobrackets.
(Pin location noted in mounting manual.)
4. Remove mount pins from loader upright.
5. Roll back bucket completely to raise uprights from
mounts.
6. Shut off engine. Disconnect hydraulics. Back tractor
away. Store mount pins in loader uprights.
To Mount Loader
1. Remove mount pins from uprights.
2. Drive tractor into loader slowly.
3. Shut off tractor. Connect hydraulics.
4. Dump bucket to lower upright into mounts.
5. Continue dumping bucket until uprights settle into
mounts, pins can be installed and stands can be
removed. Set brake and shut off tractor.
6. Install mount pins and clips. Remove stands and pin
into crosstube.
LOADER ATTACHMENT CAN FALL OFF IF NOT PROPERLY ATTACHED.
Read operator’s manuals for instructions.
Position and align loader to attachment.
Rotate coupler handles to full locked position. Lockpins must fully extend and
engage into attachment retaining slots.
Attachment mechanism must be functional and in good repair.
Only use loader manufacturer approved attachments.
For information on approved attachments, call 1-800-319-6637.
Failure to follow these instructions can result in serious injury or death.
WARNING
56055-B
WARNING
Only use loader manufacturer approved attachments.
Failure to do so can cause serious injury or death.
45024-A
6 - PN 56050
5 - PN 19924
7 - PN 56055
11 - PN 45024
9 - PN 56059
Check for leaks with cardboard; never use hand.
Before loosening fittings: lower load, release pressure, and
be sure oil is cool.
Consult physician immediately if skin penetration occurs.
WARNING
19924-B
8 - PN 260274
(WHEN EQUIPPED)
260274-C
8 - PN 45002
(WHEN EQUIPPED)
56889
10 - PN 56889
(WHEN EQUIPPED)
SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged!