Filter
Top Products
Chapter 2 - Installing the Yamaha CRW4416S Drive
5
Chapter 2 - Installing the Yamaha CRW4416S Drive
CRW4416S drive settings
Before installing the CRW4416S in your computer, you will need to set
the following jumpers.
• SCSI ID settings
• Parity setting
• Terminator setting
• Block size setting
This setting is set by inserting a jumper pin in the jumper switch
located on the rear panel of the CRW4416S drive.
Important:
Use long-nose pliers to remove or insert jumper connectors.
In the diagrams in this manual, solid black fill is used to indicate loca-
tions where a jumper is used to short between pins.
Rear Panel
■
SCSI ID settings
The SCSI ID number is used so that the computer will recognize a con-
nected SCSI device. You can assign 0 through 7 as the SCSI ID number.
Usually, “7” is reserved for the SCSI card ID number, and “0” is
reserved for the first SCSI device in the chain.
Use a number between 1 and 6 for the CRW4416S. Refer to the diagram
below for more information on setting the SCSI ID number. The factory
set ID number is “3”.
Important:
If you are using other SCSI devices, be sure to use a unique ID number
for each device.
AUDIO OUT
RGL
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
1G
SCSI
INTERFACE
CONNECTOR DC INPUT
5V
+
12V
+
Jumper Switch