Filter
Top Products
Connecting to an External Device
DME8i-C/DME8o-C/DME4io-C Owner’s Manual
Foreword
Introduction to
the DME Satellite
Controls and
Connectors
Connecting to
a Computer
Audio I/O
Connection
Connecting to an
External Device
Other Functions
References
32
CobraNet Connection (CobraNet Connectors)
You can use the CobraNet connector to control the DME Satellite’s internal head amp or other functionality.
Controlling DME Satellite’s internal head amps from a digital mixer Yamaha LS9
The internal head amp settings of a DME8i-C or DME4io-C can be remotely controlled from a digital mixer LS9.
Use the MY16-CII interface card to make CobraNet connections between the digital mixer and the DME series.
Use an Ethernet cable connected to the [NETWORK] connectors to make connections between DME series
units.
The gain and the phantom power (+48V) can be controlled from the digital mixer.
NOTE
•Only one mixer can be connected within each device group.
• The digital mixer can be connected to any DME series unit, whether it is the group master or a slave unit.
• The ID number of the DME series unit being remotely controlled is specified from DME Designer.
For details on making this setting, refer to the “DME Designer Owner’s Manual.”
•If the connection between DME series units is broken, it will no longer be possible to communicate with DME units of an
ID number that follows the disconnected DME.
USB
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
INPUT
INPUT
DIGITAL MIXING ENGINE SATELLITE
Ethernet
CobraNet
Ethernet Switching Hub
CobraNet Switching Hub
DME8i-C
DME8i-C
MY16-CII
LS9
Switching
Hub
Switching
Hub